01782 349 430

Search for:

Roof Mounted Extract Units - for control panels

Design

In some situations it is better to extract warm air from the top of an enclosure than via fans mounted inside the door panels. This is often the case when the density of equipment within the cabinet is so high that there is no room available for ventilation fans. The new modern looking "TP" series provides the panel builder with a high performance and economic answer. It is constructed from high impact polycarbonate alloy with embossed finishing and aluminium top. This aluminium top helps better dissipate the heat generated by the motor and also from within the cabinet.

Both the current all metal "T" series and the new "TP" series provide an efficient solution based on higher pressure backward curved centrifugal motorized impeller rather competitor based axial fans. Backward curved centrifugal fans have the advantage of providing strong sustainable air flow, even when the equipment density is impeding the airflow and door mounted filter units are becoming dirty. 

It is recommended that filtration should take place at the air inlet to the enclosure (Unless it has an open base).

See our page for fan/filter units.

All models mount on the roof and have no projection inside the enclosure.

Buy The T & TP Series Of Roof Fan Here

Application

Ventilation / cooling for control panels, cabinets, electronic and electrical enclosures

Technical Specification

Specification Description
FLOW RATE

800m³/h range maximum (single unit)

SIZE

375x295x119mm or 324x324x94mm

MOUNTING

Panel cut-out

No projection inside enclosure

FEATURES

Increased performances compared with door mounted fans

IMPELLERS

Backward curved only

PROTECTION

IP23/IP24/IP54/IP55

SUPPLY

Single phase ac.

MOTOR TYPE

External rotor and standard constructions

PRESSURE

According to filter size and quantity

HANDLING TEMPERATURE

Up to 60°C